Firex i5000 User Manual

Manual P/N 820-1552 Rev. A 1261-7201-00SIGNALINGLISTEDULATTENTION: Please take a few minutes to thoroughly read thisuser’s guide which should be save

4. OPERATION AND TESTINGOPERATION: The smoke alarm is operating once A.C. power is applied, freshbatteries are installed and testing is complete. Whe

Alarm Memory: This smoke alarm is equipped with an alarm memory, which provides a visual indication when an alarm has been activated. The red LED will

6. MAINTENANCEALARM REMOVALIF SMOKE ALARM TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFERTO SMOKE ALARM TAMPER RESIST FEATURE IN SECTION 3 FOR REMOVAL

USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARMREPLACEMENT.Carbon-zinc type EVEREADY 1222; GOLD PEAK 1604P OR 1604SAlkaline type ENERGIZER 522

reasonable cost; however, alarms have sensing limitations. Ionization sensingalarms may detect invisible fire particles (associated with fast flaming

• Determine a place outside your home where you all can meet if a fire occurs.• Familiarize everyone with the sound of the smoke alarm and train them

Smoke Detection – Are More Smoke Alarms Desirable? The required number ofsmoke alarms might not provide reliable early warning protection for those a

FIVE YEAR LIMITED WARRANTY (i4618, i4718 Series)Kidde warrants to the original purchaser that the enclosed smoke alarm (but not thebattery) will be fr

TEN YEAR LIMITED WARRANTY (i5000 Series)Kidde warrants to the original purchaser that the enclosed smoke alarm (but not thebattery) will be free from

Smoke Alarm ProcedureNEVER IGNORE THE SOUND OF THE ALARM!Smoke alarms are designed to minimize false alarms. Cigarettesmoke will not normally set off

A.C. Wire-in Single and/or Multiple Station (up to 24 Devices) IonizationSmoke Alarm with 9 Volt Battery Back Up and SMART HUSHTMControl totemporarily

WARNING! REMOVAL OF THE SMOKE ALARM BATTERY AND DISCONNECT-ING or LOSS OF A.C. POWER WILL RENDER THE SMOKE ALARM INOPERATIVE.ELECTRICAL RATING: 120 VA

• Install Smoke Alarms on tray-shaped ceilings (cofferedceilings) on the highest portion of the ceiling or on thesloped portion of the ceiling within

• In dusty areas. Dust particles may cause nuisance alarm or failure to alarm.• In very humid areas. Moisture or steam can cause nuisance alarms.• In

• A maximum of 24 Kidde and/or FireX devices may be interconnected in a mul-tiple station arrangement. The interconnect system should not exceed theN

BATTERY INSTALLATIONSee MAINTENANCE (Section 6) for battery installation.CAUTION! THIS UNIT WILL NOT FUNCTION WITHOUT A PROPERLYINSTALLED BATTERY, AND

NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).When wall mounting, make sure the battery box is at the bottom of the unit